A guide to Radon system Installation Thornton

Radon mitigation systems area unit nice ways that to get rid of chemical element from your home, however they’ll be difficult to put in. DIY radon mitigation isn’t any little accomplishment, except for those assured enough in their talents we tend to area unit providing bit-by-bit directions to a DIY radon mitigation

Radon system Installation Thornton is an significant addition to any home or business. Radon is fragrance-free and colorless as well as unsavory. Prolonged exposure to radon can cause cancer and is the second leading cause of lung cancer. Radon is a gas that is radioactive and is formed when uranium decays. Uranium can be initiate in rocks, water and soil all over the world in varying levels.

Knowing how old your home is will help out you plan the DIY radon mitigation system installation. If the home was built before the 1970s, the fill used beneath your cement slab groundwork is probably not ideal. An ideal fill is porous, implication it lets gas breathe. This would allow you to suck out the air somewhat easily. A non-ideal fill is dense, either very wet earth or rock. These require more effort as you need to figure out how to suck the air from side to side this dense earth and out through your system.

Radon reduction systems work and they are not too expensive. Some radon reduction systems can decrease radon levels in your home by up to 99%. Even very high levels can be cheap to acceptable levels.

How to Install Radon Mitigation

Before you install a radon mitigation system a number of things need to be considered.

  • Mark hole location on basement floor for PVC vent pipe.
  • Drill series of holes around the pipe outline with a rotary hammer.
  • Use demolition hammer to chip out hole for PVC vent pipe.
  • Pull dirt from under floor with a drill fitted with a soil-auger bit.
  • By hand, dig out enough dirt to create a hole approximately 20 inches in diameter.
  • Set the vent pipe into the hole in the basement floor, then route it up through walls and into attic.
  • Stuff foam-rubber backer rod around base of the pipe; be sure it’s slightly below the surface of the basement floor.
  • Seal around the pipe with hydraulic cement.
  • In the attic, connect PVC pipe to an electric vent fan.
  • Continue the pipe from top of vent fan through the roof and connect to a roof cap.
  • Install system monitor in basement.
  • Drill 1-inch-diameter test hole in basement floor, turn on fan and then use smoke pencil to check draw of fan.

 

RADON GETS IN THROUGH:

  • Cracks in solid floors
  • Construction joints
  • Cracks in walls
  • Gaps in suspended floors
  • Gaps around service pipes
  • Cavities inside walls
  • The water supply

 

Of course, after your system is installed you will desire to use a radon detectorto frequently monitor the system and put together sure it’s actually reducing the quantity of radon inside your home.

The next part of the article walks you through exactly what you need and what to do to install a radon mitigation system in your home.